Time is an important resource that every enterprise treasures and tries to change into a advantage. In choosing document management software, focus on a clutterless and user-friendly interface that empowers customers. DocHub provides cutting-edge instruments to maximize your document administration and transforms your PDF editing into a matter of a single click. Replace Circle in the Overtime Authorization Form with DocHub to save a lot of time and enhance your productiveness.
Make PDF editing an simple and intuitive operation that helps save you a lot of precious time. Quickly change your documents and send them for signing without turning to third-party options. Give attention to relevant tasks and enhance your document administration with DocHub right now.
Welcome To Ask Hytrol. Today we are going to demonstrate how to change the O-Ring on a Prosort SC. You will need the following tools 3/8 inch torque wrench, long screwdriver or prybar, 3/8 inch and 9/16 inch sockets, 3/8 inch impact or ratchet, 3/8 inch drive, 15/16 inch socket, 1/8 inch T-handle or allen key, 11/16 inch wrench, and a 3/8 inch allen key. For your safety and others around you always preform lock out tag out procedure on all machinery before removing any guarding for repair. Take a long screwdriver or prybar to roll the divert O-Rings off the sheaves. Remove all necessary rollers to gain access to the inside of the diverter. Now, remove the jam nuts that hold the pivot assembly down to the adjustment block screws. Also, you will need to remove the bolt going through the eye bolt on the air cylinder that mounts the cylinder to the pivot arm. You will need to lift the pivot assembly up from the divert assembly at an angle so that the O-Rings stay on the pulley below, but n