People often need to clean up engraving in LOG when working with documents. Unfortunately, few programs offer the tools you need to complete this task. To do something like this typically requires switching between a couple of software applications, which take time and effort. Thankfully, there is a platform that works for almost any job: DocHub.
DocHub is a perfectly-built PDF editor with a full set of useful features in one place. Altering, approving, and sharing paperwork is simple with our online solution, which you can use from any online device.
By following these five simple steps, you'll have your modified LOG quickly. The user-friendly interface makes the process quick and effective - stopping switching between windows. Start using DocHub now!
hello this is trevor lewis and this is another video from the voyager middle school steam lab in this video weamp;#39;re going to be looking at an engraved piece of wood this is plywood five millimeter plywood and you can see that thereamp;#39;s a lot of ash and soot that has been uh blown back down onto the surface of the finished piece so weamp;#39;re gonna look at different options for how to clean this up so there are several options one is if you like the effect you can clear coat it using some spray on clear coat and seal it in make sure to use good ventilation you can also sand it down using either manual sanding or a vibrating sander but that will sometimes get dust down into the engraving the other way iamp;#39;m trying to show you here although itamp;#39;s hard to do while holding the phone is you can use a brush and i actually have this special like stiff bristled brush that i use specifically for it it has a tendency to get a little bit messy thatamp;#39;s a good way
