At first sight, it may seem that online editors are roughly the same, but you’ll realize that it’s not that way at all. Having a robust document management solution like DocHub, you can do far more than with traditional tools. What makes our editor exclusive is its ability not only to quickly Clean print in Travel Information but also to create documentation completely from scratch, just the way you need it!
Despite its extensive editing capabilities, DocHub has a very easy-to-use interface that offers all the functions you want at your fingertips. Therefore, adjusting a Travel Information or an entirely new document will take only a few moments.
Subscribe to a free trial and enjoy your greatest-ever document-related experience with DocHub!
Have you ever found a line down the side of your 3d print? well thats called the seam and theres ways to reduce that or possibly eliminate it. if youve got a print that has a sharp corner you can do all this in Cura and Ill show you how on todays Filament Friday. Filament Friday is brought to you by these patreon supporters. this is my CHEP pawn its the first 3d design I ever did in Tinkercad and I printed this big one on my Artemis back here. when I printed it I didnt make the outer layer thick enough so its got wavy lines where the infill is actually popping through and thats easy to fix by printing with a thicker outer layer. but its also got this line going down the center thats the seam. the seam is caused when it lays the outer layer and it moves up and goes to the next layer. where it moves up it leaves a little extra plastic and if it stops at the same point all the way up you end up with a line or a seam all the way up your print. now in the Cura slicer you can adju