People often need to blot out stuff in 1ST when managing documents. Unfortunately, few applications offer the tools you need to accomplish this task. To do something like this usually involves switching between several software applications, which take time and effort. Thankfully, there is a service that works for almost any job: DocHub.
DocHub is an appropriately-developed PDF editor with a full set of useful capabilities in one place. Altering, approving, and sharing documents gets easy with our online tool, which you can use from any internet-connected device.
By following these five simple steps, you'll have your modified 1ST quickly. The user-friendly interface makes the process fast and efficient - stopping jumping between windows. Start using DocHub today!
well done you lot you gave me loads of advice on making a big lump of hard plastic now as usual half the advice contradicted the other half which made it more interesting but I picked out the bits that made most sense and tried the process again and this time it more or less worked basically I just did what I had done before but this time I squashed it in the press while it was still hot but the mold I made wasnamp;#39;t really built for that sort of pressure so it burst open and hot plastic bulged out just slipped off the bottom there which made it a little difficult to get it out of the mold now a lot of people said I should just follow other YouTubers who have done all this before and of course I would have done that but as far as I can see they havenamp;#39;t made the Big Blocks that I need I think it wouldnamp;#39;t be such a challenge at all to make smaller sized pieces or I could just go and buy those but this size is much more difficult to make and thatamp;#39;s why I could
